2. Plug jack type connector, which is connected to the “Low Paper” sensor, into
the mating connector located alongside of the 25-pin EIA connector on the rear
of the MX-85.
3. Lift the printer cover and slide the print head to approximately the center of the
printer.
4. Pull the print scale forward and push the paper release to the rear.
5. Mount the roil paper onto the paper holder.
6. Insert the paper into the slot at the rear of the platen on the MX-85.
7. Turn the black knob on the right side of the printer to feed the paper through.
8. Pull the paper release forward and align the paper.
9. Restore the paper release lever to the rear and the print scale to the rear.
Position the plastic tubes on the print scale to retain the paper firmly.
10. Close the printer cover.
MX-85 Dot Matrix Printer
Put into the two holes
Rear View of MX-85
‘Paper Holder
Fig. 16
Loading of Roll Paper (1)
- 1 7 -
Summary of Contents for M X - 8 5
