Lower
Case
Shipping Screws
1.7. Removal of shipping screws
1. Turn the MX-85 upside down, exercising care so the paper release lever is not
bent.
2. Remove the two (2) shipping screws from the lower case.
NOTE:
These shipping screws should be retained for use during reshipment of the
MX-85. They are necessary to prevent damage to the print mechanism which may
be
caused
by shock or vibration during transportation.
Right Side of the Printer
Fig. 4
Removal of Shipping Screws
1.8. Removal of the upper case
In order to check, or change, settings of the internal switches and jumpers, it is
necessary to remove the upper case.
NOTE:
Before proceeding, be sure that the MX-85 is completely disconnected from external
sources. Also, adequately discharge any static electricity which
may
be present on
your person to prevent damage to any electronic components.
1. Remove the black roller knob on the right side of the printer by pulling straight out,
firmly and steadily.
2. Remove the printer cover, as directed previously, by pulling up on its left side.
- 5 -
Summary of Contents for M X - 8 5
