- 19 -
5.
Place the new filter in the slot.
6
. Replace the Air Filter Holder.
7.
Replace the screws.
B. Replacing the left and right side pads.
The left and right side ink pads come in a kit with the
Center Air Filter. The pads are shown on the right.
It is possible to install the left and right side pads by
removing the air filter frame (Section 5A) and blindly
removing them from the pins on the base of the unit.
However, it may be easier to install the pads using the
following procedure.
To install the pads you will need to remove the Top
Cover, Front Cover and the Label Clamp Assembly.
Refer to sections 1, 3 and 4 respectively. It is possible
to replace the pads with out removing the Label Clamp
Assembly (Section 4). However, in the following
photos it has been removed to allow for a better view.
1.
Remove the saturated left and right side pads from
the printer base.
The pads are held in place by three straight pins and
one pin with a washer on top. The washer pin holds
the pad down so it will take slightly more effort to move
the pad over this pin.
