Printing on Shrink Tube
J
How to use Heat Shrink Tube
This printer prints on two sizes of heat shrink tube, 203 (1/8") and 205
(3/16").
If printing on heat shrink tube is light, turn up the print density.
Before use
1. Set the dedicated tape.
2. Enter text, and then print on the tube.
3. Put a wire through the tube.
4. Direct hot air from an industrial-use heat gun onto the entire surface of
the tube, shrinking it to the wire. Refer to the manual of your heat gun to
use it properly with heat shrink tube.
Printing a Barcode
J
Creating a label including a barcode
• Enter barcodes according to their standards.
• Check the printed labels with your barcode reader to ensure they can be
correctly read.
• Supported barcode: CODE39, CODE128, ITF, CODABAR, UPC-A, UPC-E, EAN-8,
EAN-13
1. Press +
.
2. Select an item with
, and press .
3. After setting the barcode, enter the code.
Creating a Label with a special form
To create labels with a special form, a message
confirming that the text will be deleted may
appear when
is pressed. Press to delete
the current text and to show the special form.
MEMO
To exit the following special form mode, press
, then select the "9.Exit" and press .
Specifying the Label Length
If the font size is set to "Auto", the font size will adjust automatically
allowing you to create labels of a specified length.
1. Press
.
2. Select "Label length" with
, and press .
3. Select a value with
or enter it, and press .
Maximum length: 40cm (15.0 inch)
"Auto": Adjusts to the proper length automatically.
4. Select a text alignment setting with
, and press .
5. Press
.
6. Select "Auto" with
, and press .
7. Enter text.
Create Folder Tab Label
J
Creating a folder tab label
1. Press
.
2. Select from "1.Tab:Medium", "2.Tab:Small" or "3.Tab:Large" with
,
and press .
3. Select a value with
or enter label length, and press .
Maximum length: 12.5cm (5.0 inch)
4. Enter text.
Create a Ribbon Label
J
Creating a ribbon
1. Press
.
2. Select "8.Ribbon" with
, and press .
3. Select a value with
or enter it, and press .
Length range: 20-40 cm (8.0-15.0 inch)
4. Enter text.
Cable Labels
J
Creating a label for cables
Flag labels wrapping a cable
1. Press
.
2. Select from "4.Flag:Hori.", "5.Flag:Vert." or "6.Flag:Edge" with
, and
press .
3. Select a value with
or enter label length, and press .
Maximum length: 12.5cm (5.0 inch)
4. Enter text.
Labels wrapping a cable
1. Press
.
2. Select "7.Wrap" with
, and press .
3. Select a value with
or enter label length, and press .
Maximum length: 12.5cm (5.0 inch)
4. Enter text.
9
