Epson Endeavor VL, Specifications

Page: 5 / 11

EPSON Endeavor VL
System board components
Other DIP switch settings
Jumper and DIP Switch Settings
Factory set according to system CPU
External cache jumper settings
Factory setting; change jumpers only if external cache chips are installed at
factory or by servicer
Clock speed DIP switch settings
Clock speed*
25
MHz
33 MHz
Switch 1
OFF
ON
Switch 2
OFF
ON
Switch 3
ON
OFF
Factory set according to system type; DX2/50 and DX2/66 systems are set at
25 and 33 MHz, respectively
-
SIMM Installation
The computer comes with 4MB of memory soldered on the
system board. By installing SIMMs you can increase the
amount of memory in your computer up to 40MB.
Each of the three SIMM sockets on the main system board
can contain one 4MB or 16MB memory module. The
following table shows the possible SIMM configurations; do
not install memory in any other configuration.
SIMM configurations
SIMM 1 SIMM 2
0 0
4MB 0
4MB 4MB
SIMM 3 Total
0 4MB*
0 8MB
0 12MB
4MB 4MB 4MB 16MB
16MB 0 0 20MB
4MB 16MB 0 I24MB
I
16MB 16MB 0 36MB
4MB 16MB 16MB 40MB
l
Standard memory on the system board
Before you install SIMMs, observe the following guidelines
to ensure that they will work properly:
Use only 32- or 36-bit, 72-pin, tin-plated, fast-page mode
SIMMs that operate at an access speed of 70ns or faster.
Be sure all the SIMMs operate at the same speed.
Your computer can use any SIMM that complies with
industry standards.
Supported SIMMs
3/94
EPSON Endeavor VL-5