Epson ELPMB60, Installation Manual

Page: 5 / 244

Using the Product Safely
3
Warning
When securing the mount, do not use adhesives to prevent the screws from loosening,
and do not use lubricants, oils, and so on.
If you use adhesives to prevent the screws from loosening, or if you use things such as lubricants
or oils, the mount or the projector case may crack and fall or topple over causing an injury or an
accident.
Do not hang from the mount or the projector, and do not place heavy objects on them.
Otherwise, the mount or the projector may fall or topple over and could cause death or injury.
Do not apply excessive force to the projector or the mount when installing.
Otherwise, the mount or the projector may be damaged and could cause death or injury.
Do not install in the following situations. Contact your local dealer or Epson Service Call
Center.
•
If the product has been dropped or damaged before or during installation
•
If the mount is abnormal or damaged
Warnings and Cautions on the Installation Locations
Warning
Check the structure and material of the surface to which the mount will be installed, and
use the optimum installation method.
Make sure the surface to which the mount will be installed is strong enough.
Do not install the mount or projector in an unstable location where it might be subjected
to vibrations or shocks.
The surface to which the mount is attached may be damaged. Also, the mount or projector may
fall or topple over and cause an injury or accident to occur.
Do not install in a location that is not strong enough to bear the load or that is slanted.
The installation location needs to be strong enough to support the projector and this product.
Check the weight of the projector and this product before installation, perform calculations of
allowable weight and so on, and then install them securely.
Do not install or use the projector in locations where it could be exposed to rain or water,
such as outdoors, in baths or shower rooms.
Otherwise, it could cause a fire or electric shock.
Do not use the projector in a location subject to combustible or explosive gas.
If the inside of the projector gets too hot, it could ignite and cause a fire.
Do not cover the projector's air intake vent or air exhaust vent.
If either of the vents are covered, the projector's internal temperature could rise and cause a fire.