Epson EH-LS500B, User Manual

Page: 79 / 112

Troubleshooting
78
Check Remedy
Do the indicators turn on and off when the
power cord is touched? Turn off the projector, and then disconnect and reconnect the
projector's power cord. If the problem continues, stop using the
projector, remove the power plug from the electrical outlet, and
contact your local dealer or the nearest projector information
center.
s
Epson Projector Contact List
Problems with the remote control
The remote control does not respond
Check Remedy
Is the remote control light-emitting area
pointing towards the remote receiver on the
projector during operation? Point the remote control towards the remote receiver. Also,
check the operating range.
s
p.21
Is the remote control too far from the projec-
tor? Check the operating range.
s
p.21
Is direct sunlight or strong light from fluores-
cent lamps shining onto the remote receiver? Set the projector up in a location where strong light does not
shine onto the remote receiver.
Are the batteries dead or have the batteries
been inserted correctly? Make sure the batteries are inserted correctly or replace the bat-
teries with new ones if necessary.
s
p.21
Problems with the control panel
Cannot make settings on the control panel
Check Remedy
Is Control Panel Lock set to Full Lock or Par-
tial Lock ?
When Control Panel Lock is set to Full Lock in the Configura-
tion menu, all button operations on the control panel are disa-
bled; when
Partial Lock is set, only the standby button on the
control panel is available. Perform operations from the remote
control.
s
Settings - Lock Setting - Control Panel Lock p.61
Problems with 3D
Cannot project correctly in 3D
Check Remedy
Are the 3D Glasses turned on? Turn on the 3D Glasses.
Are the 3D Glasses fully charged? Charge the 3D Glasses.
Is a 3D image being projected? If the projector is projecting a 2D image, or if an error occurs on
the projector that prevents the 3D image from being projected,
you cannot view 3D images even if you are wearing the 3D
Glasses.
Is the input image in 3D? Check that the input image is 3D compatible.
Since most TV broadcasts do not contain a 3D format signal, 3D
reception must be set manually.