You cannot make settings on the Signal menu when the source is USB
Display, USB, or LAN.
s
"Automatically Detect Input Signals and Change the Projected Image
Submenu
Function
Auto Setup
Set to
On
to automatically adjust Tracking, Sync., and Position to
the optimum state when the input signal changes.
Resolution
Set to
Auto
to automatically identify the resolution of the input
signal. If images are not projected correctly when set to
Auto
, for
example if some of the image is missing, adjust to
Wide
for wide
screens, or set to
Normal
for 4:3 or 5:4 screens depending on the
connected computer.
Tracking
You can adjust computer images when vertical stripes appear in
the images.
Sync.
You can adjust computer images when flickering, fuzziness, or
interference appear in the images.
Position
You can adjust the display position up, down, left, and right when
a part of the image is missing so that the whole image is projected.
Submenu
Function
Progressive
(When a component video or RGB video is being input, this
setting can only be adjusted if the signal being input is an
interlaced signal (480i/576i/1080i). This cannot be set when a
digital RGB signal is being input.)
Interlace
(i) signal is converted to Progressive
(p). (IP
conversion)
Off
: Ideal for images with a large amount of movement.
Video
: Ideal for general video images.
Film/Auto
: This is ideal for movie films, computer graphics, and
animation.
Noise Reduction
(This cannot be set when a digital RGB signal is input, when
projecting an interlaced signal while
Progressive
is set to
Off
, or
when a 480p, 576p, or 1080p signal is input while
Image
Processing
is set to
Fast
.)
Smoothes out rough images. There are two modes. Select your
favorite setting. It is recommended that this is set to
Off
when
viewing image sources in which noise is very low, such as for
DVDs.
HDMI Video
Range
When the projector's HDMI port is connected to a DVD player,
set the projector's video range according to the DVD player's
video range setting.
Input Signal
You can select input signal from Computer port.
If set to
Auto
, the input signal is set automatically according to
the connected equipment.
If colors do not appear correctly when set to
Auto
, select the
appropriate signal according to the connected equipment.
Video Signal
You can select the input signal from the Video port. If set to
Auto
,
video signals are recognized automatically. If interference
appears in the image or a problem occurs such as no image is
being projected when set to
Auto
, select the appropriate signal
according to the connected equipment.
Aspect
You can set the aspect ratio
for projected images.
s
"Changing the Aspect Ratio of the Projected Image"
List of Functions
76
Summary of Contents for EB-S03
