D
After the correction is performed, the following message
appears. To exit the correction menu, press the [Esc button]
on the remote control or the control panel to clear the
message.
To fine-tune the projected image after it has been corrected,
make the adjustments using the [
][
][
][
] buttons
on the control panel.
s
Procedure 3 on
If no operation is performed, the message closes after about 5
seconds.
After Screen Fit is executed,
Keystone
from the Configuration
menu is set to
Quick Corner
. After this, any correction of the
projected image using [
][
][
][
] buttons on the
control panel will be done through the Quick Corner function.
s
q
•
Screen Fit corrects the projected image when it detects two or
more sides inside the projected area, and aligns with the detected
frame. For example, when projecting onto a wide screen in a
small room, you can make corrections by fitting the top and
bottom sides of the screen into the projected area.
•
Screen Fit may not work well in dark environment, such
as a room with lights turned off. In this case, make the
room brighter, then try executing Screen Fit again.
•
Because Screen Fit uses a sensor, it may not work
properly depending on the condition of the projected
surface (deflections, patterns and the like) or the effects
of outside light. In this case, make the adjustments
manually.
s
Quick Start Guide
Correcting the Projected Image Using Screen Fit (EB-1925W/1915 Only)
25