46
Chapter2 Setup
How to Load Paper (Auto Cutter Model - Supply from Inside)
1
Turn on the printer, and then check that [Internal] is selected as the [Media Source]
setting on the operation panel.
"Operation Panel Settings" on page 145
)
2
Open the paper cover.
3
Remove the spindle from the printer.
As shown in the figure, hold the spindle and flange with both hands, and remove them.
4
Load the roll paper on the spindle and fix it with the flange.
•
To move the flange, squeeze the two levers.
•
When loading the roll paper on the spindle, take note of the winding direction. The correct wind-
ing direction is marked on the spindle.
•
Fix the flange and roll paper so that there is no gap in between.