S a v e M o n e y a n d I m p r o v e Y o u r P r i n t i n g
MIS Associates Inc 2901 Auburn Rd Auburn Hills, MI 48326 800-445-8296
http://www.inksupply.com Fax: 248-289-6013 Email: [email protected]
Top of printer does not have to be removed.
5.
Clean and dry the top of the printer housing with alcohol and place the Right Hand
Bracket as shown in the photo. Lubricate tubes with alcohol and slide them into the
Right Hand Bracket. Once the tubes are securely inserted into the Right Hand
Bracket, un-web the tubes from the right edge of the bracket to the end so that
each tube can be independently installed into its bottle. The tubes are easily un-
webbed by just pulling them apart, no tools are required. Don't go too far.
6.
If your system was prefilled, cut the tubes just above the light blue pinch clips.
You will lose about 1/2" of tubing, this is OK. If you ordered an empty system you
will not have any pinch clips to cut off. Cut the end of the tubes on a 30 degree
angle so they are pointed. Don't waste any tube length in doing this.
Arrange the bottles in the bottle tray like shown in the top photo. Now insert the
tube into the bottle so the tube reaches the bottom of the bottle. There should be
3 1/2 to 3 3/4 inch of tubing inside the bottle when you are finished. Don't put the
wrong color tube into the wrong ink bottle. Tubes and bottles are marked. Tubes
either have color tags on them or there are traces of ink in the prefilled tubes.
7.
Push the cartridges down all the way until they click. Make sure they are properly
aligned and down all the way. This is important. Push the cartridges all the way to
the right, until they stop.
8.
Plug the printer back in and turn on the power. Run a few cleaning cycles until you
have a perfect nozzle pattern. The printer is now ready to use. If you have
problems getting a perfect nozzle pattern, let the printer rest overnight, and try
again in the morning.
