background image

S a v e   M o n e y   a n d   I m p r o v e   Y o u r   P r i n t i n g

 

MIS Associates Inc                2901 Auburn Rd                Auburn Hills, MI  48326                 800-445-8296

  

http://www.inksupply.com                             Fax: 248-289-6013                           Email: sales@inksupply.com  

1.

 

Fill Carts if Needed

 - If you purchased your system prefilled, then go to Step 2. 

If the cartridges are empty (no ink in tubes), then vacuum fill the cartridges with 
the ink that came with the system or the ink of your choice. Follow the instructions 
that came with the MIS Vacuum Pump. When this is complete, go to Step 2. 

 

2.

 

Free Carriage

 - On the printer, push the 

Ink button

 (this is the one that has ink 

drop icon on it) to move the cartridges to the 

Replace

 position. While in this 

position, 

pull the power plug out of the wall

 

3.

 

Remove the Epson cartridges and PARTIALLY install the CFS cartridges. Do not 
push the cartridges all the way down. We do not want the seals on the bottom to be 
punctured until the tubes have been installed in the bottles. 

 

 

 

4.

 

Install the Middle Bracket on the inside surface of the printer housing. The 
opening on the bracket should point up. Place it as high as possible. Looking from 
the back of the printer, the right edge of the clear bracket should be about one 
half inch to the left of center of the printer. See photo below. 

 

The tubing is marked with two vertical black lines. This is where the tube goes into 
the bracket. Use some alcohol on the tubes to get them inserted into the clear 
bracket.  

 

If you tube does not have the black marks on it, then put marks at 8 3/8 and 9 3/8 
from the edge of the black cartridge. 

 

Install the Velcro strip over the ribs on the inside of the housing as shown in the 
photo to protect the tubes when they rub or touch the housing. 

 

Summary of Contents for C80 CFS

Page 1: ...e best way to do this is first print a Nozzle pattern using the printer utility software provided by Epson If the nozzle pattern is perfect then print 5 copies of the MIS PURGE4 TIF image using the Plain Paper and 360 dpi settings on the printer The Purge4 image can be found on the diskette included with your system or download it from our website All 5 pages must print without banding or skipping...

Page 2: ...rtridges and PARTIALLY install the CFS cartridges Do not push the cartridges all the way down We do not want the seals on the bottom to be punctured until the tubes have been installed in the bottles 4 Install the Middle Bracket on the inside surface of the printer housing The opening on the bracket should point up Place it as high as possible Looking from the back of the printer the right edge of...

Page 3: ...K If you ordered an empty system you will not have any pinch clips to cut off Cut the end of the tubes on a 30 degree angle so they are pointed Don t waste any tube length in doing this Arrange the bottles in the bottle tray like shown in the top photo Now insert the tube into the bottle so the tube reaches the bottom of the bottle There should be 3 1 2 to 3 3 4 inch of tubing inside the bottle wh...

Page 4: ...it on your printer power line Set it to turn on the printer once per day When the printer first comes on it will do a cleaning cycle This is equivalent to making a Purge6 print With the timer installed you will not have to leave your computer on Most hardware stores carry these timers they are not expensive If you have to do cleaning cycles do them in groups of 3 Print a copy of Purge4 or Purge6 a...

Reviews: