Related Information
&
“Making Wi-Fi Settings by Push Button Setup” on page 19
&
“Making Wi-Fi Settings by PIN Code Setup (WPS)” on page 20
&
“Making Wi-Fi Direct (Simple AP) Connection Settings” on page 21
Making Wi-Fi Settings by Push Button Setup
You can automatically set up a Wi-Fi network by pressing a button on the wireless router. If the following
conditions are met, you can set up by using this method.
❏
The wireless router is compatible with WPS (Wi-Fi Protected Setup).
❏
The current Wi-Fi connection was established by pressing a button on the wireless router.
Note:
If you cannot find the button or you are setting up using the software, see the documentation provided with the wireless
router.
1.
Hold down the [WPS] button on the wireless router until the security light flashes.
If you do not know where the [WPS] button is, or there are no buttons on the wireless router, see the
documentation provided with your wireless router for details.
2.
Hold down the
button on the printer for at least five seconds until the
light and the
light flash
alternately.
The connection setting will start. When a connection is established, the
light turns on.
Note:
The printer is in a connection error status when the
light and the
light flash simultaneously. After clearing
the printer error by pressing the
button on the printer, reboot the wireless router, place it close to the printer and try
again. If it still does not work, print a network connection report and check the solution.
User's Guide
Network Settings
19
