❏
The power-supply cords should be placed to avoid abrasions, cuts, fraying, crimping, and kinking. Do not place
objects on top of the power-supply cords and do not allow the power-supply cords to be stepped on or run over.
Be particularly careful to keep all the power-supply cords straight at the ends and the points where they enter
and leave the transformer.
❏
If you use an extension cord with the printer, make sure that the total ampere rating of the devices plugged into
the extension cord does not exceed the cord's ampere rating. Also, make sure that the total ampere rating of all
devices plugged into the wall outlet does not exceed the wall outlet's ampere rating.
❏
If you plan to use the printer in Germany, the building installation must be protected by a 10 or 16 amp circuit
breaker to provide adequate short-circuit protection and over-current protection for the printer.
❏
When connecting the printer to a computer or other device with a cable, ensure the correct orientation of the
connectors. Each connector has only one correct orientation. Inserting a connector in the wrong orientation
may damage both devices connected by the cable.
❏
Place the printer on a flat, stable surface that extends beyond the base of the printer in all directions. The printer
will not operate properly if it is tilted at an angle.
❏
When storing or transporting the printer, avoid tilting it, placing it vertically, or turning it upside down;
otherwise ink may leak.
❏
Allow space above the printer so that you can fully raise the document cover.
❏
Leave enough space in front of the printer for the paper to be fully ejected.
❏
Avoid places subject to rapid changes in temperature and humidity. Also, keep the printer away from direct
sunlight, strong light, or heat sources.
❏
Do not insert objects through the slots in the printer.
❏
Do not put your hand inside the printer during printing.
❏
Do not touch the white flat cable inside the printer.
❏
Do not use aerosol products that contain flammable gases inside or around the printer. Doing so may cause fire.
❏
Do not move the print head by hand; otherwise, you may damage the printer.
❏
Be careful not to trap your fingers when closing the document cover.
❏
Do not press too hard on the scanner glass when placing the originals.
❏
Always turn the printer off using the
P
button. Do not unplug the printer or turn off the power at the outlet
until the
P
light stops flashing.
❏
Before transporting the printer, make sure that the print head is in the home (far right) position and the ink
cartridges are in place.
❏
If you are not going to use the printer for a long period, be sure to unplug the power cord from the electrical
outlet.
Advisories and Warnings for Using the Printer with a Wireless
Connection
❏
Radio waves from this printer may negatively affect the operation of medical electronic equipment, causing
them to malfunction. When using this printer inside medical facilities or near medical equipment, follow
directions from the authorized personnel representing the medical facilities, and follow all posted warnings and
directions on the medical equipment.
❏
Radio waves from this printer may negatively affect the operation of automatically controlled devices such as
automatic doors or fire alarms, and could lead to accidents due to malfunction. When using this printer near
automatically controlled devices, follow all posted warnings and directions on these devices.
User's Guide
Important Instructions
13
