Epson AcuLaser C8500, Service Manual

Page: 237 / 570

EPSON AcuLaser C8500 Revision C
Disassembly/Assembly/Adjustment Disassembly/Assembly Procedures 3-85
3.2.12.17 EXIT-1 ROLL ASSY (PL9.3.14) Removal
1. Remove the EXIT TRAY ASSY. (See Section 3.2.13.1.)
2. Remove the FUSER ASSY. (See Section 3.2.12.1.)
3. Remove the MAIN FUSER ASSY. (See Section 3.2.12.2.)
4. Remove the E-ring securing the FUSER KNOB and FUSER KNOB GEAR.
Remove the FUSER KNOB, FUSER GEAR and FUSER KNOB WASHER.
5. Remove the E-ring securing the EXIT KNOB GEAR.
6. Slide the EXIT KNOB GEAR to the rear and remove the EXIT ROLL PIN.
7. Slide the front EXIT-1 BEARING to the rear, and slide the front of the EXIT-
1 ROLL ASSY to the right.
NOTE: The rear EXIT-1 BEARING of the EXIT-1 ROLL ASSY remains but is
not secured to the FUSER TRAY when the following step of the
procedure is performed. Be careful not to lose the EXIT-1 BEARING.
8. Slide the EXIT-1 ROLL ASSY forward and dismount the rear of the EXIT-1
ROLL ASSY. Remove to the rear the EXIT-1 ROLL ASSY together with the
EXIT 1 GEAR and EXIT-1 BEARING.
9. Remove the EXIT-1 BEARING and the EXIT 1 GEAR from the EXIT-1
ROLL ASSY.
Figure 3-94. EXIT-1 ROLL ASSY Removal