Inserting and Removing Diskettes
To insert a diskette into a 3.5-inch drive, hold the diskette with
the label facing up and the shutter leading into the drive, as
shown in the following illustration. Slide the diskette into the
drive until it clicks into place.
To insert a diskette into a 5.25-inch drive, hold the diskette with
the label facing up and the read/write slot leading into the
drive. When the disk is completely in the drive, turn down the
latch to secure the diskette in the drive.
When you want to remove the diskette, make sure the drive
light is off; then press the release button or turn the latch.
Remove the diskette and store it properly.
caution
Never remove a diskette, reset the computer, or turn it off
while a diskette drive light is on. You could lose data. Also,
remove all diskettes before you turn off the computer.
3-4
Using Your Computer
Summary of Contents for ActionDesk 4000
