Epson 6110i - PowerLite XGA LCD Projector, User Manual

Page: 105 / 130

Solving Problems
105
Solving Problems with the Remote
Control
The projector doesn’t respond to remote control commands.
■ If you’re using the remote control for the first time, make sure the
batteries are installed, as shown on page 43.
■ The remote control’s batteries may not be installed correctly or
may be low on power. To change the battery, see page 43.
■ Make sure you are within 33 feet (10 meters) of the projector, and
within range of the projector’s front or back sensor
(approximately 30° to the left or right and 15° above or below).
■ Dim the room lights and turn off any fluorescent lights. Make
sure the projector is not in direct sunlight. Strong lighting,
especially fluorescent lights, may affect the projector’s infrared
receivers. Also, turn off any nearby equipment that emits infrared
energy, such as a radiant room heater.
■ Make sure the projector’s remote receivers aren’t turned off; see
page 59.