Installation and Configuration
S5U13743P00C100 Evaluation Board
Seiko Epson Corporation
7
Rev. 1.1
3 Installation and Configuration
The S5U13743P00C100 evaluation board incorporates a DIP switch, jumpers, and 0 ohm
resistors which allow it to be used with a variety of different configurations.
3.1 Configuration DIP Switch
The S1D13743 has 3 configuration inputs (CNF[2:0]). A DIP switch (SW1) is used to
configure CNF[2:0] as described below.
The following figure shows the location of DIP switch SW1 on the S5U13743P00C100
board.
Figure 3-1: Configuration DIP Switch (SW1) Location
Table 3-1: Summary of Power-On/Reset Options
SDU13743P00C100
SW1-[4:1] Config
S1D13743
CNF[2:0] Config
Power-On/Reset State
1 (ON)
0 (OFF)
SW1-[1]
CNF0
Host Data lines are normal
Host data lines are swapped
SW1-[2]
CNF1
Host Data is 16-bit
Host data is 8-bit
SW1-[3]
CNF2
PIOVDD output current = 6.5mA
PIOVDD output current = 2.5mA
SW1-[4]
-
not used
= Required settings when using S5U13U00P00C100 USB Adapter board
DIP Switch
SW1
