Epsolar ET2415N, Instruction Manual

Page: 29 / 64

Page
24
This interface will pop out if you input correct
password and press to save, and the controller
will run with new parameters. Otherwise, it will run
with default value if illegal parameter is set. You
have to look over carefully and repeat setting
operation.
﹡
Set control voltage point, please in strict accordance with: Over Volt. Disc
＞
Charge
Limit
＞
Equalize Charge
＞
Boost Charge
＞
Float Charge
＞
Boost Volt. Rect or
Under Volt. Rcvr
＞
Under Volt. Warn
＞
Low Volt. Disc
＞
Discharge Limit, Please refer
to chapter 8 Parameters about control voltage table while setting.
Press or to change value. Press or
to move inverse cursor, this interface includes Over
Volt. Disc
(
Over Voltage Disconnect Voltage
)
and
Over Volt. Rect
(
O
ver Voltage Reconnect Voltage
).
Parameters will be displayed as corresponding default
values after correct system voltage identification.
Press or to change value. Press or
to move inverse cursor, this interface includes Charge
Limit
(
Charging Limit Voltage
)
and Equalize Charge
(
Equalize Charging Voltage
).
Parameters will be
displayed as corresponding default values after
correct system voltage identification.
Press or to change value. Press or
to move inverse cursor, this interface includes Boost
Charge
(
Boost Charging Voltage
)
and Float Charge
(
Float Charging Voltage
).
Parameters will be
displayed as corresponding default values after
correct system voltage identification.
Tip Message
Modify OK
OK
Over Volt. Disc
16.0V
Over Volt. Rect
15.0V
+
_
↓ ↑
Charge Limit
15.5V
Equalize Charge
14.6V
+
_
↓ ↑
Boost Charge
14.4V
Float Charge
13.8V
+
_
↓ ↑