26
© 2006, Elektro-Automatik GmbH & Co. KG
Irrtümer und Änderungen vorbehalten
EN
Instruction Manual
BC 800 R Series
Date: 02-09-2012
IV. Temperature sensor input
The temperature sensor alters the charging voltage
according to the ambient temperature of the battery, if
placed in proximity, or to the battery surface tempera-
ture if placed directly on the battery.
It is important to only use sensors with 10mV/K. Allowed
temperature range for charging is -15°C...50°C.
The included sensor is a LM335, pin assigment as
shown above. Always connect with correct polarity
according to the wiring scheme.
5.10 Activate automatic charging mode
Note: the automatic charging mode requires swit-
ching the device to remote control. No manual control
possible during remote control. It means, in case the
current limitation „I-Limit“ is going to be used, it must
be activated before. The battery type (LEAD ACID etc.)
also has to be selected before.
Automatic charging means
a) the charging will automatically start after the mains
supply is switched on, but only if a battery is connected
and no error is present
b) the charging will automatically start as soon as a
battery is connected to the running charger, but only if
no error is present.
In order to activate this mode, it is required to set
bridges on the analogue interface, which also could
be replaced by switches if manual switching is favor-
ed. Using bridges, the charging procedure can not be
stopped manually.
If the charging is done (green LED of traffic light), ano-
ther battery can be charged.
Attention! In case a the load is connected to the battery
in parallel it may draw current from the charger. A high
current consumption is considered as an empty battery
by the charger and it will change to boost or precharge
mode again, altering the output voltage.
6. Miscellaneous
6.1 Resetting the control panel
In the rare case the device will not respond to manual
control, the control can be reset. This is done by pres-
sing and holding pushbutton „Charging profiles“ while
the device is powered on. This will reset following:
• Output off
• Power Supply Mode selected
• I-Limit activated with BC 8288-02R model, on other
models deactivated
Handling the device
Bottom view
(pin ADJ is not used)
Summary of Contents for BC 800 R Series
Page 2: ......
Page 9: ...9 Bedienungsanleitung BC 800 R Serie DE Stand 09 02 2012 4 1 Ansichten und Maße Beschreibung ...
Page 27: ......
Page 28: ......