ePropulsion SPIRIT 1.0 Plus, User Manual

Page: 32 / 104

30
6.2 Error Codes and Solutions
When the outboard is running in abnormal conditions or malfunctioning, a
warning message will display with an error code. The table below will help
you get a solution.
Code Description Solution
E01
Motor Over
Voltage
Stop the motor and wait until the error message
disappears. If the problem still exists, contact your
dealer for repairing.
E02
Motor Over
Current
Disconnect the battery and check if the motor is blo-
cked. If not, continue driving at low speed. If this issue
cannot be solved, please contact your dealer.
E03/
E04 Motor
Overheating Wait a few minutes until the motor cools down and the
warning message disappears.
E05
Motor Under Volta-
ge
Indicate the battery level is extremely low. The out-
board can probably be restarted at lower speed after
the message is dismissed.
E10 Motor Blocked
Disconnect the battery and remove anything that is blo-
cking the motor. Make sure the propeller can be rotated
by hand smoothly.
E20
Battery
Communication
Fault
Turn off the motor and reconnect the battery cable. If
this issue cannot be solved, please contact your dealer.
E21
Motor Communica-
tion Fault Turn off the motor and reconnect the battery cable. If
this issue cannot be solved please contact your dealer.
E30
Throttle Calibration
Required
Calibration process:
1. Press and hold "SELECT" button (≥10secs) until
"CAL Fo" is displays.
2. Rotate the throttle forward to full power position
and press "SELECT" button. "CAL ST" will display.