Stand 02.01.09, GB 32, Geared head drill
Page 32 of 54
4.9
Activate coolant flow
Open the plugs fort he coolant
Activate the coolant pump with the switch
„coolant pump“
The coolant pump starts to work as soon as you activate the drive.
4.10 Machine light
The machine has an illumination at the working face. The switch therefore is
located at the face side of the drilling head.
4.11 Centre sleeve fetching
The centre sleeve is turned back by dint of the heald spring motion. The heald
spring motion is balanced at the weight of the centre sleeve and clamped tool.
You can adjust the heald spring motion by declamping the central screw at the
spring housing and turn the complete housing and arrest again.
4.12 Working notes
4.12.1
General notes
Remove all unnecessary work parts (tool etc.) from the machine
Ascertain that the running direction is given
Check the blameless condition of the tool
Only work with orderly tool
Only use Step drills, HSS drills, hole saws or reamers that are
adequate for the material
4.12.2
Fixing the work part in the vice
Ascertain that the work part is clamped correct and feast in the vice
Shore up overlaying parts with a support block
Summary of Contents for GB 32
Page 5: ...Stand 02 01 09 GB 32 Geared head drill Page 5 of 54 20 ACCEPTANCE CERTIFICATE 54 ...
Page 37: ...Stand 02 01 09 GB 32 Geared head drill Page 37 of 54 7 Exploded drawing 7 1 Table foot ...
Page 40: ...Stand 02 01 09 GB 32 Geared head drill Page 40 of 54 9 2 Exploded drawing gear housing 2 ...
Page 45: ...Stand 02 01 09 GB 32 Geared head drill Page 45 of 54 13 2 Exploded drawing drilling head 2 ...
