EPOX EP-BX6, User Manual, Page: 48 / 77

BIOS EP-BX6
Page 4-16
4-6 Load Setup Defaults
The “LOAD SETUP DEFAULTS” function loads the system default data directly
from ROM and initializes the associated hardware properly. This function will be
necessary only when the system CMOS data is corrupted.
4-7 Integrated Peripherals
Figure 7: Integrated Peripherals
Note: If you do not use the onboard IDE connectors, then you will need
to set Onboard Primary PCI IDE: Disabled and Onboard second-
ary PCI IDE : Disabled. The onboard PCI IDE cable should be
equal to or less than 18 inches (45cm).
IDE HDD Block Mode: IDE Block Mode allows the controller to access blocks
of sectors rather than a single sector at a time. The default is Enabled.
Enabled: Enabled IDE HDD Block Mode. Provides higher HDD transfer
rates.
Disabled: Disabled IDE HDD Block Mode.
Esc : Quit : Select Item
F1 : Help PU/PD/+/- : Modify
F5 : Old Values (Shift) F2 : Color
F7 : Load Setup Defaults
ROM PCI/ISA BIOS(2A69KPAI)
INTEGRATED PERIPHERALS
AWARD SOFTWARE, INC.
IDE HDD Block Mode : Enabled
IDE Primary Master PIO : Auto
IDE Primary Slave PIO : Auto
IDE Secondary Master PIO : Auto
IDE Secondary Slave PIO : Auto
IDE Primary Master UDMA : Auto
IDE Primary Slave UDMA : Auto
IDE Secondary Master UDMA : Auto
IDE Secondary Slave UDMA : Auto
On-Chip Primary PCI IDE : Enabled
On-Chip Secondary PCI IDE : Enabled
USB Keyboard Support : Disabled
Init Display First : PCI Slot
POWER ON Function : Hot Key
KB Power ON Password : Enter
Hot Key Power ON : Ctrl-F1
Onboard FDC Controller : Enabled
Onboard Serial Port 1 : 3F8/IRQ4
é é
é é
é ê
ê ê ê ê è è è è è ç ç ç ç ç
Onboard Serial Port 2 : Disabled
UART Mode Select : Normal
UART2 Duplex Mode : Half
RxD, TxD Active : Hi, Lo
IR Transmission delay : Enabled
Onboard Parallel Port : 378H/IRQ7
Parallel Port Mode : ECC+ECP
ECP Mode Use DMA : 3
EPP Mode Select : EPP1.7
PWRON After PWR-Fail : Off