EPOX EP-BX6, User Manual, Page: 42 / 77

BIOS EP-BX6
Page 4-10
4-4 Power Management Setup
Choose the “POWER MANAGEMENT SETUP” in the CMOS SETUP UTILITY to
display the following screen. This menu allows the user to modify the power
management parameters and IRQ signals. In general, these parameters should not
be changed unless it’s absolutely necessary.
Figure 5: Power Management Setup
You can only change the content of Doze Mode, Standby Mode, and Suspend
Mode when the Power Management is set to ‘User Define’.
ACPI Function: This option allows you to select ACPI Function.
The default is Enabled.
Enabled: Support ACPI function for new O.S
Disabled: No Support ACPI function.
ACPI Suspend Type: This item allows you to select S1(POS) or S3(STR) function.
The choice: S1(POS), S3(STR).
Power Management: Use this to select your Power Management selection.
The default is User define.
Disabled: The system operates in NORMAL conditions (Non-GREEN),
and the Power Management function is disabled.
ROM PCI/ISA BIOS (2A69KPAI)
POWER MANAGEMENT SETUP
AWARD SOFTWARE, INC.
ACPI Function : Enabled ** Reload Global Timer Events **
ACPI Suspend Type : S1(POS)
Power Management : User Define IRQ [3-7, 9-15], NMI : Disabled
PM Control by APM : Yes Primary IDE 0 : Disabled
Video off Method : V/H SYNC+Blank Primary IDE 1 : Disabled
Video off After : Standby Secondary IDE 0 : Disabled
Modem Use IRQ : 3 Secondary IDE 1 : Disabled
Doze Mode : Disabled Floppy Disk : Disabled
Standby Mode : Disabled Serial Port : Enabled
Suspend Mode : Disabled Parallel Port : Disabled
HDD Power Down : Disabled
Throttle Duty Cycle : 62.5%
PCI/VGA Act-Monitor : Disabled
Soft-off by PWR-BTTN : Instant-off
CPUFAN Off In Suspend : Enabled
PowerOn By Ring : Enabled
Resume by Alarm : Disabled
Wake Up On LAN : Enabled
IRQ 8 Break Suspend : Disabled
Esc : Quit : Select Item
F1 : Help PU/PD/+/- : Modify
F5 : Old Values (Shift) F2 : Color
F7 : Load Setup Defaults
é é é é é ê
ê ê ê ê è è è è è ç ç ç ç ç