EPOX EP-8HDA5I, User Manual, Page: 27 / 94

Installation
Page 3-11
SATA1 / SATA2: Two Serial ATA Connectors
SATA3 / SATA4 / SATA5 / SATA6 (Optional):
Four Serial ATA Connectors from Silicon Image
SiI3114 chip.
These connectors enable you to connect Serial
ATA devices that conform to the Serial ATA
specification.
SATA2
SATA1
SATA3 SATA4
LED1: 80 Port Debug LED
Provides two-digit POST code to show why the
system fail to boot. Allows quick and easy
optimization.
80 Port Debug 7-segment LED display
(Refer to Appendix C for POST codes)
1
GND
A- B- B+ GND A+
GND
SATA5
SATA6
CUSB3/CUSB4: Four USB 2.0 ports
This mainboard includes 2 additional USB2.0 ports,
identified by two 10-pin connector.
If you wish to use the additional USB ports, install
the card-edge bracket to the system chassis then
insert its cables to this 10-pin connector.
CUSB3 CUSB4
CAUTION !
Please make sure the USB cable has the same pin assignment. A different pin assignment
may cause damage to the system. If you need the USB cable, please contact our retailer.