Electrical Safety Information
Compliance is required with respect to the voltage,
frequency, and current requirements indicated on
the manufacturer’s label. Connection to a different
power source than those specified herein will
likely result in improper operation, damage to the
equipment or pose a fire hazard if the limitations are
not followed.
There are no operator serviceable parts inside this
equipment. There are hazardous voltages generated
by this equipment which constitute a safety hazard.
Service should be provided only by a qualified service
technician.
Contact a qualified electrician or the manufacturer
if there are questions about the installation prior to
connecting the equipment to mains power.
label which means that the equipment has been
tested to the following Directives and Standards: This
equipment has been tested to the requirements for
the CE Mark as required by EMC Directive 2014/30/
EU as indicated in European Standard EN 55032 Class
B and the Low Voltage Directive 2014/35/EU as in
European Standard EN 60950-1.
General Information to all Users: This equipment
generates, uses and can radiate radio frequency
energy. If not installed and used according to this
manual the equipment may cause interference
with radio and television communications. There
is, however, no guarantee that interference will not
occur in any particular installation due to site-specific
factors.
Emissions and Immunity Information
Notice to Users in the United States: This equipment
has been tested and found to comply with the limits
for a Cflass B dfigfitafl devfice, pursuant to Part 15 of
FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates,
uses, and can radiate radio frequency energy, and
if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
Notice to Users in the European Union: Use only
the provided power cords and interconnecting
cabling provided with the equipment. Substitution
of provided cords and cabling may compromise
electrical safety or CE Mark Certification for emissions
or immunity as required by the following standards:
This Information Technology Equipment (ITE) is
required to have a CE Mark on the Manufacturer’s
1.
In order to meet emission and immunity
requirements, the user must observe the following:
a.
Use only the provided I/O cables to connect this
digital device with any computer.
b.
To ensure compliance, use only the provided
manufacturer’s approved line cord.
c.
The user is cautioned that changes or modifications
to the equipment not expressly approved by the
party responsible for compliance could void the
user’s authority to operate the equipment.
2.
If this equipment appears to cause interference
with radio or television reception, or any other
device:
Verify as an emission source by turning the
equipment off and on. If you determine that this
equipment is causing the interference, try to correct
12
13
Summary of Contents for KDS
Page 1: ...KDS User Manual...
