Epoch Design Seneca Twin over Full Quick Start Manual Download Page 4

Page: 4 / 4

Have a question? Need a part ASAP? Call 1-800-589-7990 or email [email protected].

Insert a bunk connector pin

into each of the four holes

on the bottom end boards.

Then with assistance place

the upper bunk on top of the

lower bunk.

Attach ladder to side rail of upper bunk.

Now use the hex key to retighten all bolts

so that bunk bed assembly is rigid.

Be sure to periodically tighten hardware

as it may loosen with usage

and changing humidity.

**NOTE:

Do not affix ladder if you have

purchased under bunk drawer.

If desired, you may permanently

affix the ladder to either side of

the short safety rail by using two

15mm round head screws.

13-Aug-2018

4/4

Summary of Contents for Seneca Twin over Full

Page 1: ...ot remove warning label from bed Periodically check and ensure that the guardrail ladder and other components are in their proper position free from damage and that all connectors are tight Do not use...

Page 2: ...s Used to connect lower end boards 2x Lower end boards Used on lower bunk 1x Short safety rail Used on the ladder side of the upper bunk 2x Upright spports Used to attach long safety rails to upper si...

Page 3: ...or the lower bunk Note The propel nuts are pre installed into the bed rails and face away from the 45mm bolts as shown Use 45mm bolts to attach the long safety rail to the side rail on the back wall s...

Page 4: ...r bunk Attach ladder to side rail of upper bunk Now use the hex key to retighten all bolts so that bunk bed assembly is rigid Be sure to periodically tighten hardware as it may loosen with usage and c...