To build the long safety rail attach the two long safety
rails to the upright supports using eight 45mm bolts.
Please note that the head of the threaded inserts face away
from the 45mm bolts as shown. Tighten with the hex key.
Pre-drilled holes
Have a question? Need a part ASAP? Call 1-800-589-7990 or email [email protected].
Assemble the twin upper bed by attaching
the upper end boards to the upper side
rails with the pre-drilled holes
for safety rail attachment.
Insert barrel nuts into side
rails. Insert 100mm bolts
through end boards and
into the barrel nuts.
1
2
3
4
5
6
Tighten 100mm bolts with the 5mm Allen Wrench provided.
LEDGE
Unroll the slat bundle and lay
it out strap side down on the
upper bunk.
Repeat step 1
Using the parts for the lower bunk.
**Note:
The propel nuts are pre-installed into the bed
rails and face away from the 45mm bolts as shown.
Use 45mm bolts to attach the long safety rail to
the side rail on the back wall side of the upper bed.
To install the center support
beam align the center rail support
(wood side up) between the two headboards,
insert 80mm bolts through the end boards and
into barrel nuts installed in the center support.
Using a Phillips head screwdriver and 30mm
slat screws secure the first slat on one end,
then the final slat on the other end making
sure the slats have been distributed evenly.
Then secure the remaining slats to the rails.
**Note:
A power screwdriver with clutch set on
low is useful here.
Using a Phillips head screwdriver
and 30mm slat screws secure the
first slat on one end, then the final
slat on the other end making
sure the slats have been
distributed evenly.
Then secure the
remaining slats to the rails.
13-Aug-2018
3/4
