page | 12
www.snapav.com Support 866.838.5052
ES-SUB-ELE10-450 & ES-SUB-ELE12-700*
*ES-SUB-ELE12-700 pictured
8
7
9
10
11
6
5
3
2
1
4
12
13
100-120V
220-240V
POWER
HIGH LEVEL
CROSSOVER
PHASE
VOLUME
STATUS
AUTO
OFF
ON
IN
L
R
OUT
LFE
LOW LEVEL
IN
OUT
ES-SUB-ELE12-700
Designed and Engineered in USA
Manufactured in China
50
LFE
0
˚
180
˚
MIN
MAX
100
CAUTION:
For continued Protection against risk
of fire, replace only with same type
fuse and rating.
ATTENTION:
Utiliser un fusible de rechange de
meme type et calibre.
FUSE T6.3AL/250V
100-120V~60Hz 4A /
220-240V~50Hz 2A
DC 5V
/500mA
1. STATUS LED
Red- Subwoofer is in standby mode, or power mode switch is set to OFF. AC power is present.
Blue- Subwoofer power mode switch is set to ON, or is set to AUTO and signal is being received.
2. Power Mode Switch
3 way toggle switch for setting power mode to OFF, AUTO, or ON.
3. Volume Knob
Adjust subwoofer volume.
4. Phase Knob
Set the phase of the subwoofer in relation to the listening area. Continuously variable from 0 to 180°.
5. Crossover Knob
Adjust the crossover frequency (limits the highest frequency the subwoofer will play).
Note:
Set the crossover knob to “LFE” if the LFE input is used.
6. LOW LEVEL Inputs & Outputs (RCA)
For left/right or LFE connections from audio source, and outputs for connecting other equipment. To connect
LFE, use the L (left) channel connections.
7. HIGH LEVEL Inputs & Outputs (Speaker Wire Binding Post)
Connect left/right connections from speaker cable runs, and loop to other speakers.
8. Voltage Selector Switch
Select the input voltage. Default: 100-120V.
9. Master Power Switch
Rocker switch to turn power off to the subwoofer. Power LED will be off if switch is off but power is present.
10. Power Cord Inlet
Connect the included cord for providing power.
11. Fuse Holder (ES-SUB-ELE-10 and 12 Only)
Master Power fuse. See Specifications for the correct size and rating for the model in use. Includes spare fuse
inside holder.
Note:
ES-SUB-ELE10 Uses FUSE T4AL/250V 100-120V‒60Hz 2.5A/220-240V‒50Hz 1.25A.
12. USB Port
A 5V USB port on the subwoofer back panel provides a power source for an Episode Wireless receiver.
Note:
Successful operation is not guaranteed with devices other than the Episode Wireless Kit. (Wireless Kit
sold separately.
13. Wireless Receiver Holding Bolts
Secure the Wireless receiver to the subwoofer.
www.snapav.com Support 866.838.5052
Summary of Contents for ES-SUB-ELE10-450
Page 1: ...INSTALLATION MANUAL ES SUB ELE8 250 ES SUB ELE10 450 ES SUB ELE12 700 ...
Page 2: ......
Page 15: ......
Page 16: ... 2018 Episode Rev 180525 1020 ...