• Strip the insulation on each conductor approximately ¼” and insert to the speaker terminals.
Ensure that there are no stray strands of wire protruding from the connectors. Observe proper
polarity (+ to + and – to – for each speaker and at the amplifier) and that right and left surround
channels are connected properly.
• Insert the speaker into the ceiling and tighten each of the four screws for the speakers ‘dog’
legs enough to clamp the speaker against the ceiling.
EpisodE 100 sEriEs in-CEiling spEakErs with 6 1/2 in. woofEr
An ideal choice for budget-conscious applications, the Episode ES-150-IC-6 offers both quality
and affordability. And with it’s 3” total depth (2-1/4” inside ceiling area assuming ½” dry-wall)
it is an excellent problem solver when you’re faced with minimal ceiling clearance. Great for
background listening in commercial or residential applications.
IMPORTANT INSTRUCTIONS AND CONSIDERATION
• Read and understand all instructions.
• Before beginning installation, carefully plan locations accounting for potential
electrical, plumbing or other obstacles.
• Contact a suitable contractor if you are unsure of how to best install.
INSTALLATION
NEW CoNSTRuCTIoN
Episode speaker installation can be simplified by using an Episode new construction
bracket (Sold Separately). This is installed prior to drywall, and allows for precise
placement and eases the final installation of the speaker.
EXISTING CoNSTRuCTIoN
Speaker wire must be run from the equipment or volume control location to each
potential speaker location.
• Choose a location for each speaker that is free of obstructions created by joists,
HVAC ductwork, electrical wire runs, plumbing or anything else that might not allow
for the depth of the speaker or create interference or noise.
SIDE VIEW OF CEILING
First Cut
45°
90°
Second Cut
CAUTION: Do not overtighten
screws. This could result in
speaker damage, ceiling damage
or both.
• Once you have determined your locations, mark the hole to cut out for the speaker
using the supplied template. Don’t forget to allow for the size of the speaker bezel
if you are choosing to install the speaker near a side wall or other item that could
become an obstacle.
• If you are unsure of potential obstacles, carefully cut your holes using an angle to
the inside of the cutout area as illustrated. This will allow you to ‘plug’ the hole easily
if needed. If the area is clear and is a good location for the speaker, go ahead and
cut the edges of the opening at 90 degrees to accommodate the speaker diameter.
