page | 7
© 2018 Episode®
5.
Insert the speaker into the opening from below. Tighten the dogs on the speaker, making sure they clamp on the
sheet rock. Be careful- over tightening the clamps can cause the speaker bezel to warp and may crack the ceiling.
TAP SETTING
After the speaker is installed, set the transformer to the correct setting.
WARNING!
Do not set the speaker for 8 ohm operation if using 70V or 100V amplifier. This could cause permanent
damage to the speaker or amplifier.
70V Setting
100V Setting
70V Setting
100V Setting
SPECIFICATIONS
ECS-800-IC-4
Woofer:
4" Polypropylene
Tweeter:
¾" Silk Dome
Power Handling:
30 Watts RMS (@ 8 Ω)
Nominal Impedance:
8 Ohms
Tap Settings:
- 70V: 3.8w, 7.5w, 15w, 30w
- 100V: 7.5w, 15w, 30w
- 8 Ω Bypass
Frequency Response (-6dB):
70Hz - 20kHz
Sensitivity -2.83 V / 1 Meter:
84 dB
Weight:
6.1 lbs. each
Crossover Frequency:
3.3kHz
Grille Type:
Perforated Steel Grille
Cutout Dimensions:
6.8" Diameter
ECS-800-IC-6
Woofer:
6½" Polypropylene
Tweeter:
1" Silk Dome
Power Handling:
65 Watts RMS (@ 8 Ω)
Nominal Impedance:
8 Ohms
Tap Settings:
- 70V: 7.5w, 15w, 30w, 60w
- 100V: 15w, 30w, 60w
- 8 Ω Bypass
Frequency Response (-6dB):
70Hz - 19kHz
Sensitivity -2.83 V / 1 Meter:
87 dB
Crossover Frequency:
2.8 kHz
Weight:
8 lbs. each
Grille Type:
Perforated Steel Grille
Cutout Dimensions
8.8" Diameter
