www.snapav.com Support 866.838.5052
page | 8
FINE TUNE
After making all connections and calibrating the speakers, fine tune the subwoofer
as instructed below.
NOTE:
When using an AV receiver and the LFE input, set the subwoofer
calibration level to the factory setting.
1. Ensure that the subwoofer is plugged in.
During initial setup, set the ‘POWER MODES’ switch to the ‘ON’ position. Once
calibration is complete, switch to ‘AUTO’ to enable the automatic power-
saving mode. For reference, the different modes are as follows:
AUTO:
Auto sense enabled. Amplifier turns on when audio signal is detected. Unit
enters standby mode if no signal is sensed after 15 minutes.
2. Select one of the three preset EQ’s on the back of the amplifier. Preset EQ’s are
optimized for use with ES-SUB-SNGL-8 in wall / in ceiling subwoofers. Choose
the correct EQ setting depending on the air volumes behind the subwoofer.
For example, smaller air volumes will have a larger bump in the EQ.
EQ PRESET A:
+4dB (optimized for enclosures > 4 cu. ft.)
Example:
ES-SUB-SNGL-8 in a free air installation (no back box)
HIGH LEVEL
OUT
IN
STATUS
CROSSOVER
PHASE
VOLUME
0
10
60
LFE
0
180
EQ A
EQ C
EQ B
L
R
LINE IN
LFE
FUSE T2AL/250V
100-120V AC
220-240V AC
+
-
+5V GND
SPK OUT
WLS
L+ L
-
R+ R
-
100-120V~60Hz
220-240V~50Hz 100WATTS
HIGH LEVEL
OUT
IN
STATUS
CROSSOVER
PHASE
VOLUME
0
10
60
LFE
0
180
EQ A
EQ C
EQ B
L
R
LINE IN
LFE
FUSE T2AL/250V
100-120V AC
220-240V AC
+
-
+5V GND
SPK OUT
WLS
L+ L
-
R+ R
-
100-120V~60Hz
220-240V~50Hz 100WATTS
LS
RS
SUB
CEN
L
R
Switched
Outlet
+ 12V Trigger
Out
+
-
EA-MINI-SUB-1D-100
ESS-SUB-SNGL-8
AVR/SOURCE
