www.snapav.com Support 866.838.5052
page | 4
AMPLIFIER
A. Mounting Ears
Mount the unit to a wall or rack using the mounting ears.
B. High Level Input and Output (For Speaker Wire)
For left/right connections from speaker cable runs.
C. Low Level Inputs (RCA)
For left/right or LFE connections from audio source. To connect LFE, use the L (left)
channel.
D. Status LED
Red
- Standby mode, or power mode switch is set to OFF. AC power is present.
Blue
- Power mode switch is set to ON, or is set to AUTO and signal is being received.
E. Volume Knob
Adjust subwoofer volume.
F. Speaker Output (Green)
Connect output to screw-down terminals.
G. 5V and Ground Connection
Connect 5VDC power for wireless kit.
H. Voltage Selector
Selects the appropriate input voltage setting: 120V or 230V
I. Crossover Adjustment Knob
Adjust the crossover frequency (limits the highest frequency the subwoofer
will play).
Note:
Set the crossover knob to “LFE” if the LFE input is used.
J. Phase Adjustment Knob
Set the phase of the subwoofer in relation to the listening area.
K. EQ Settings
EQ Preset A: +4dB (optimized for enclosures > 4 cu. ft.)
EQ Preset B: +7dB (optimized for enclosures 1-4 cu. ft.)
EQ Preset C: +10dB (optimized for enclosures < 1 cu. ft.)
Note:
See fine tuning section on page 8 for details on use of EQ setting
L. Power Connection
Connect the included cord for providing power.
SETUP
A
B
H
C
E
I
J
K
F
G
D
L
