PRO 32 & 48 X-AXIS BELT
6
During the job, the x-axis motor RMS current
should be between 5.2 - 6.2A.
If the RMS current is lower than this,
increase the tension on the x-axis belt by
tightening the two (2) 7/64” hex screws on
the x-axis idler assembly.
If the RMS current is higher than this,
decrease the tension on the x-axis belt by
loosening the two (2) 7/64” hex screws on the
x-axis idler assembly.
10. Once the optimal RMS current value
has been achieved, tighten the four (4)
7/64” idler mounting screws at the front
of the x-axis assembly and the four (4)
7/64” hex screws at the rear of the x-axis
assembly:
11. Replace the left panel of the engraver:
If further assistance is required, please
contact Epilog Laser Technical Support
by email at [email protected], or by
phone at 303-215-9171.
