Epic 600 Mx Treadmill, User Manual

Page: 8 / 30

8
6. Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the
treadmill to protect the floor or carpet.
For your benefit, we recommend that you familiarize yourself with
the TROUBLESHOOTING section on pages 22 and 23.
5. Remove the backing from the indicated tape on the con-
sole assembly. Press the Book Holder (62) firmly onto
the tape. Note: The Book Holder may be preassembled.
If you purchase the optional chest pulse sensor (see
page 19), follow the steps below to install the receiver
included with the chest pulse sensor.
1.
Make sure that the power cord is unplugged.
Remove
the indicated Screw (2) and the Access Door (95).
2. Remove the paper from the adhesive pad on the back of
the receiver (A).
Orient the receiver so the small cylin-
der is near the lower edge of the receiver and is fac-
ing the Console Back (85) as shown.
Firmly press the
receiver onto the indicated corner of the Access Door
(95). Connect the wire on the receiver to the Pulse Wire
(49) extending from the Console Back.
3.
Make sure that no wires are pinched.
Reattach the
Access Door (95) with the Screw (2). Note: The other
wires included with the receiver may be discarded.
Console
Assembly
62
Tape
5
A
85
95 Cylinder
2
49