24
Chapter 4 stacker Maintenance
1 Operational safety and environmental protection
The servicing and inspection operations contained in this chapter must be performed in
accordance with the intervals indicated in the servicing checklists.
Any modification to the stacker assemblies, in particular the safety mechanisms, is prohibited.
The operational speeds of the stacker must not be changed under any circumstances.
Only original spare parts have been certified by our quality assurance department. To ensure
safe and reliable operation of the stacker, use only the manufacturer's spare parts. Used
parts, oils and fuels must be disposed of in accordance with the relevant environmental
protection regulations. For oil changes, contact the manufacturer’s specialist department.
Upon completion of inspection and servicing, carry out the activities listed in the
“Recommissioning” section.
2 Maintenance Safety Regulations
Maintenance personnel:
Industrial stackers must only be serviced and maintained by the
manufacturer’s trained personnel. The manufacturer’s service department has field
technicians specially trained for these tasks. We therefore recommend a maintenance
contract with the manufacturer’s local service centre.
Lifting and jacking up:
When an industrial stacker is to be lifted, the lifting gear must only be
secured to the points specially provided for this purpose. When jacking up the stacker, take
appropriate measures to prevent the stacker from slipping or tipping over (e.g. wedges,
wooden blocks). You may only work underneath a raised load handler if it is supported by a
sufficiently strong chain.
Cleaning:
Do not use flammable liquids to clean the industrial stacker. Prior to cleaning, all
safety measures required to prevent sparking (e.g. through short circuits) must be taken. For
battery-operated stackers, the battery connector must be removed. Only weak suction or
compressed air and non-conductive antistatic brushes may be used for cleaning electric or
electronic assemblies.
If the stacker is to be cleaned with a water jet or a high-pressure cleaner, all electrical and
electronic components must be carefully covered beforehand as moisture can cause
malfunctions.
Do not clean with pressurised water.
After cleaning the stacker, carry out the activities detailed in the “Recommissioning” section.
Summary of Contents for ES10-10WA
