03
04
Maintenance
7
.
Stable operation
Travel of stacker shall be stable, avoiding sharp turns and sudden start.
8
.
Loose or unstable stacking of goods or overloaded cargoes are prohibited.
Loose or unstable stacking of goods will cause falling of goods, or even turnover.
9
.
Other safety requirements
Do not use this stacker on the muddy ground.
Do not operate the stacker unless you have carefully checked its condition. Pay special attention
to the wheels, the handle assemblies, the frame, the chains, etc.
The operator shall wear safety shoes and gloves for protection.
Do not use the stacker in a potentially flammable and explosive atmosphere.
Do not use the stacker as a vehicle jack.
Do not use the stacker during strong wind forces.
Do not use the stacker on places insufficiently illuminated.
Do not use the stacker on a slopping ground.
The weight of goods should be distributed evenly on the two forks, do not use only one fork. The
center of gravity of goods beyond the two forks is forbidden.
The stacker shall be charged in places properly ventilated and far away from the fire.
Stacker should be parked on a smooth place, with its brake pressed, power turned off and the
forks lowered to the min. height.
Stop using the stacker without guarding plate.
Under special conditions or in special locations, the operator should be careful while operating
the stacker.
No modifications or alterations to the parts of the stacker, especially the safety device shall be made
without permission. All original spare parts have been checked by the quality inspection departments.
To ensure the safety and reliability of the stacker operation, only the manufacturer's spare parts can be
used. Replaced parts, such as batteries and waste oil, must be disposed in accordance with the
appropriate environmental protection rules.
Only customer service persons specially trained by our company can carry out maintenance of the
truck. Thoroughly standardized maintenance is the most important preconditions to ensure stable
and reliable operation performance of the stacker. Neglect of regular maintenance could result in
failure and malfunction of the truck and poses a potential threat to the safety of the staff and
operation.
Warning
1
.
Hydraulic oil
Please check the oil level every six months and change the oil every twelve months. 32 # hydraulic
oil is recommended, with total volume of about 4.0 liters.
2
.
Routine maintenance
It is necessary to check and maintain the stacker daily for sound application. Special attention should
be paid to:
(1)The wheels, the axles, as foreign bodies may block the wheels and axles,
(2)
The fork and the frame which may be deformed. and
(3)
If the battery voltage is normal. The forks should be unloaded and lowered in the lowest position
when the job is over.
3
.
Lubrication
Use motor oil or grease to lubricate all movable parts.
4
.
Maintenance of battery
Keep all nuts tight, dry and clean. Each wiring terminal and cable joints must be tightened and coated
with clean grease. The exposed wiring terminals and binding posts of the battery must be covered with
insulated cover.
Figure 2
Safe operating rules
S10/15 Series Semi-electric Pallet Stackers
