KNX Home-Modul - Installation and Operating Instructions
21
Mounting and electrical installation
3
To ensure that the address has been configured successfully, check that
the HOME icon is displayed on the control unit.
4
If the HOME icon is not displayed, repeat the programming step.
Please note that the address increases by one each time you press the
programming button, e.g. from 4 to 5.
4.4 KNX programming
The SBM GLT KNX should be operated with software version ETS5 or
higher. In the ETS project, a corresponding unit must be created and con-
figured.
Programming the KNX address
1
Press the KNX programming button.
Programming mode is activated. The programming LED lights up.
2
Load the physical address into the KNX Home-Modul.
3
Load the user software into the KNX Home-Modul.
4
Check the display of the building management system to verify that the
cabin is displayed.
5
Close the SBM GLT KNX housing.
4.5 Emotec, EmoStyle, EmoStyle i, Emotec IR,
InfraStyle, InfraStyle i data communication
When the building management system and the KNX Home-Modul are
connected, you must define the transfer protocol. Familiarity with the gen-
eral operating functions is assumed.
1
0
1
2
1
1
6
J 1
R 5
C 12
C 7
C 1
IC 4
6
R 9
R 10
2
S L1
IC 2
D1
D2
L1
L3
R 11
R 12
C 3
K L1
IC 8
R 13
R 15
R 16
R 18
C 6
C 10
IC 7
L4
C 5
D5
OK 4
C 13
C 16
C 18
IC 1
LE D1
R 53
S W 1
LE D1
R 53
S W 1
