KNX Home-Modul - Installation and Operating Instructions
15
Mounting and electrical installation
Mounting and electrical installation
This chapter describes how to mount and wire the SBM GLT KNX.
NOTICE
Equipment damage
Corrosive environments or environments with high levels of saline
in the air could damage lines and circuit boards.
Only use the KNX Home-Modul in a non-corrosive environment.
4.1 Mounting the KNX Home-Modul
Tools + hardware
Drill
Wood screws 4 x 25 mm
Mounting on a fixed wall: Screws 4 x 25 mm and suitable anchors
The KNX Home-Modul is intended to be mounted on the outer wall of the
cabin or in the utility room. The maximum cable length between the relay
box and the KNX Home-Modul is 10 m.
Mounting the housing
1
Drill 2 holes at the top and another 2 at the bottom of the wall.
The housing can be mounted either vertically or horizontally.
2
Use anchors if necessary.
3
Loosen the housing screws on the cover.
Horizontal distance between drill holes: 63.5 mm
Vertical distance between drill holes: 113.5 mm
