EOS Ecomat, Assembly And Operating Instruction

Page: 26 / 43

26 GB
Initial start-up
The heater is taken into operation by turning
the on/off-switch
After it has been swit-
ched on, the heater will be heating during 4
hours and cut off automatically.
The operating status „on“ is shown by a
green LED.
The red LED is illuminated additionally whi-
le the heater is heating up.
After the heating period of 4 hours the
green LED keeps on being illuminated and
the red LED is slowly blinking.
The on/off-switch must be turned to „0“ to
disconnect the heater. The red and green
LED will go out.
0
2
00
133
0
8
thermostat
on/off-switch
The sauna must heat up for approximately
45 minutes to achieve a typical sauna cli-
mate.
The thermostat enables you to select the
temperature you desire within a range of
approx. 40° C to 110° C. Please remember,
however, that the sensors register only the
temperatures in their immediate vicinity.
Therefore, temperatures may differ in other
parts of the cabin. These differences are
typical for sauna climates, however.
The sauna heater is activated through a
clock timer with synchronous motor.
In consequence of the power frequency
(50 Hz) the synchronous motor is making
some noise.
This is not a fault or insuffi ciency of the he-
ater !
Indication
Is the bathing temperature not obtainable
or is the temperature different from the ca-
bin thermometer?
Please consider that the temperature sen-
sor is located in the area of the heating
system. The thermometer can be
fi xed
at different places (f.ex. on the cabin wall
above the bench). The sensor can only feel
the ambient temperature. A difference of
25 cms between sensor and thermometer
might cause a difference in temperature
upto 15°C.
Furthermore, many bimetal thermometers
react with delay, showing the real tempe-
rature after one hour only. If possible the
thermometer should not touch the cabin
wall with the hole rear side and should be
mounted with a space to reduce the re-
sponse time.
It is absolutely possible that your thermo-
meter shows a lower value than it has been
set on the control box.
Troubleshooting
Oven doesn‘t work: Let check the micro-
fuse by an electrician.
The red LED is blinking quickly
Cause: Sensor and / or limiter is defective
Ask a specialist to check the sensor and
limiter.
The Limiter and the Sensor are located in
the sensor housing over the sauna oven
Limiter
0 Ohm = ok
= faulty
Sensor
An important value is the resistance at
normal room temperature. At 20°C, this is
about 1,9 kOhm
8