EOS Zeus S / EOS Zeus SL - Installation and Operating Instructions
EN-49
Maintenance
Inserting the heating coil
1
Insert the heating coil in the lower grate.
2
Insert the top and bottom steel plate and tighten the 8 screws.
3
Lift the heating element in the heater and rotate it until you see the
3 screw holes.
4
Screw in the 3 bottom screws and tighten them.
5
Position the stone grate in place and tighten the 3 screws.
6
Position the decoration ring in place and tighten the 6 screws.
7
Place the stones loosely on the stone grate.
See
8
Reconnect the power supply.
Replacing the entire heating coil
1
WARNING! Ensure that no power is supplied to the unit. Allow the heater
to cool down.
Loosen the connection cable at the relay box.
2
Remove the old heating coil.
See
3
Insert the new heating coil.
See
4
Connect the connection cable at the relay box.
5
Reconnect the power supply.
