EOS 46.U, Assembly And Operating Instruction, Page: 24 / 39

24
EN
Attach a warning sign near the
water funnel
Fig. 3
Fig. 4
ATTENTION
The infusion occurs retarded. Pour the water
with a ladle in small portions into the funnel.
The water will fl ow down to the sauna rocks in
the oven by the silicone hose and will be evenly
distributed over the rocks thanks to the special
water gutter inside the heater.
The uprising hot air will distribute the steam
across the sauna cabin, creating the famous
“steam shock” eff ect.
Remember that the sauna rocks must heat up
again after each infusion in order to produce an
intensive steam.
Pay attention that only a limited amount of
water may be evaporated at a time. Therefore,
wait approximately 8 to 10 minutes for the next
water splash.
ATTENTION
Make sure to install the supplied safety grill
above the sauna heater as shown on previous
page - see fi g. 1, fi g. 2 and fi g. 2a.
Pay attention to safety gaps. Risk of fi re!
1120
700
200
170
stone basket
water pan
water funnel
sauna stones
sauna stones
elbow pipe
silicontube
Water splash eff ects through the supplied wa-
ter funnel via the silicone hose and the L-shape
elbow attached to the heater.
The connection may be on the left or on the
right hand side. Depending on the connection
side you may need to turn the water distri-
bution gutter inside heater around, so that
this gutter, so that it declines from the water
connection point to the opposite end.
To do this loosen two fi xation screws on both
ends of the gutter, take it out of the heater,
turn it around, place it back into position and
secure it again with the fi xation screws.
Insert the elbow (angled tube piece) into the
hole above the gutter on the side wall of the
Mounting the water funnel
heater. Make sure it sits tightly.
Mount the funnel at the suitable place to the
sauna wall or partition wall with 2 screws.
Pay attention that the funnel should be placed
well above the gutter level.
Connect the funnel and the connector with the
silicone tube. The tube should decline to the
connector, the contact with the heater must
be avoided.