Envision Matrox Concord, Installation And Hardware Reference Manual

Page: 15 / 40

Installing Matrox Concord 15
5. If present, remove the blank metal plate located at the back of the selected slot.
Keep the removed screw; you will need it to fasten the Matrox Concord board.
6. For Matrox Concord F-series, if your cameras will draw more than .5 A total (4W)
over the three 1394b connectors of the board combined, you should attach a power
cable to the board, as described in the
Using the power connector section section.
7. Carefully position the Matrox Concord board in the selected empty
PCI/PCI-X/PCIe slot. Once perfectly aligned with the slot's connector, press the
board firmly but carefully into the connector.
Important
8. Anchor the board by replacing the screw that you removed.
9. Attach your cameras as described in the Connecting devices to Matrox Concord
section section.
10. Turn on your computer.
❖
When you boot your computer, Windows' Plug-and-Play system will detect a new
Multimedia Video Device and you will be asked to assign it a driver. At this point,
you should click on
Cancel because the driver will be installed during the
installation of Matrox Concord software.