15
If the Probe sensors become coated with a very
heavy layer of biological growth, emulsions, or other
materials, the Probe will not function properly. The
Probe can be cleaned, as shown below, using spray
cleaner or mild dish liquid in warm water and a cloth
or soft bristled brush. Care must be taken to avoid
damaging the Probe and sensor bands, either by
brushing too hard or by using a very hard tool to
perform cleaning.
Make sure that the Product Inlet Slots
and holes are clear, and the interior
Alpha Array™ Sensor Band area is free
of coating and debris
If persistent residue sticks inside the sensor area, a
soft brush or tooth brush is recommended to fully
clean sensors.
ALPHA ARRAY™
SENSOR BAND
AREA
END CAP
PRODUCT
INLET SLOT
PRODUCT/WATER
INLET HOLES
The product inlet
slots lie toward
the end of the
probe, which
allows the
product to flow
into the pump
filter. There are
also several
round holes,
which allow water
and product to
freely flow into
the inside of the
probe pump
cavity where the
sensor bands are
located. These
holes must all be
kept clean.
Envirotecnics
Tel: +34 872 080 542
envirotecnics@envirote
cnics.com
www.envirotecnics.com
