Page
18
IM,
O&M Instructions – Heat Pump
Before commissioning please ensure you have read and understood the General Health & Safety Precautions
Note to installing engineer:
The Toshiba Outd
oor
unit must be set up using an RBC-AMT32E /
RBC‐
AMS41E controller. Please refer to Toshiba
Technical Literature or call
Toshiba 24 hour Technical Helpline 0870 843 0333
Operation
Location
Checked
Checks before power applied
Isolator and circuit breaker in the off position
Unit installed with clear air inlet and outlet paths
Bottom and top face
All packaging and installation materials removed
Internal
Fans freely rotating
Internal
All panels and electrical covers refitted and secure
Bottom/ top face/internal
Unit clean and free from damage
All
Refrigeration circuit check for leaks (Heat Pump units only)
All pipe work
Fully wired to wiring diagram issued
N/A
All electrical terminations tight
Control panel, Switch and
unit
Checks with power applied
Only undertake these test
once all covers have been
refitted and unit is
electrically safe
Fan speeds correct (if applicable)
Switch
Heat function correct (if applicable)
Switch
Run on Timer operates (if applicable – set for 3 minutes)
Controls
If you have noticed that some kind of trouble (such as when an error display has appeared, there is a smell of
burning, abnormal sounds are heard, the door curtain fails to heat or water is leaking) has occurred, do not touch
the door curtain yourself but set the isolator/circuit breaker to OFF position and contact a qualified service person.
Take steps to ensure that the power will not be turned on (by locking off supply and by marking “Out of service”
near the circuit breaker for instance) until the qualified service person arrives. Continuing to use the door curtain
in the trouble status may cause mechanical and electrical problems that could escalate or result in electric shocks
etc.
13.0 Commissioning
13.0 Troubleshooting
