11
ok, lets, set the clock and start this system up
led screen and what you see when the system is on
installation Instructions - all systems - electrical connection
INSTALL eLeCTRICAL CONNeCTION
9.
Connect electrical power by plugging the system nto a standard grounded and unswitched 110/115/120v electrical
outlet.
If outlet is over 16 feet away use 18 gauge extension cord to connect up to 100 feet away. Do not exceed 100 feet.
do not cut or splice original equipment.
NOTe: POWeR CONSUMPTION
Power consumption is that of a radio alarm clock or a doorbell.
CAUTION:
If the home’s plumbing system is copper (or any metal) then it may be necessary to install a jumper.
Install a jumper between the incoming and outgoing pipes before and after the flexible stainless
connections to maintain the continuity of the systems’ ground. Properly ground system to conform
with all codes and ordinances.
4#_ SRV 00:00PM
REGEN IN 06 DAYS
Set Up Button
Adjusts Clock Up
Adjusts other settings
as needed
Set Down Button
Adjusts Clock Down
Adjusts other settings
as needed
Shift Button
Adjusts Cursor Position
extra
Cycle
Button
Diagnostic Button
last Two regens
(filter system only)
Status LeD
Blue
= In service
Green
= In regen
(backwash for filter)
Red
= error Mode
Green Display Screen
Time of day
Regen (self-clean for filter) Day
In service
Alternates with error screen if
errors are present
Days Count Down to next Regen
(self-clean, backwash filter only)
Factory Pre-set is every 6 days
Time of day
hours, Minutes, AM or PM
In Service
will read INI for 30-45 seconds
after a power failure reset or
programming
System #
4 Indicates a Filter system
Single Tank Residential
or light Commercial
NOTe:
day & Time are the only changes needed.
system does not need any additional programming.
Please follow the instructions and allow system to
run through the pre-programmed start-up and flush.
Summary of Contents for CWL-1354-1.5
Page 18: ...18...
