Envirologix QuickSCan II, User Manual, Page: 23 / 25

19
Don't spray cleaner directly onto the glass. Do not use glass cleaners that
contain acetone, ammonia, benzene, or carbon tetrachloride. Allow a few
seconds' drying time before closing cover. Clean Test results can be
viewed with different backgrounds and pixel colors by toggling the radio
buttons in the results window. Close window to return to the Main Menu.
 Periodically examine the scanner surface for visible debris or markings. If
the surface appears dirty, clean the glass plate as described above. If the
scanner surface has been scratched or cracked in any way, contact
EnviroLogix Technical Support.

Periodically inspect the tray. Gently brush or wipe away any build up of
sample material.
DAILY MAINTENANCE
Recommended daily maintenance:

Calibrate the QuickScan unit using the "Calibrate" button on the main
screen. A record of calibration will be stored in the DataLog.

Perform the Clean Test. Clean the scanner surface, place the White Card
into the drawer
and click the “Clean Test” button on the main screen. A
record of the Clean Test will be stored in the DataLog.

Scan the Check Comb. Place the Check Comb into the tray and click the
“Read Test” button on the main screen. Ensure that the results fall within
the Expected Values range.
ERROR MESSAGES
QuickScan has internal diagnostic capability that detects scanning,
processing or configuration errors requiring corrective action. The following
table identifies common error codes and recommended corrective actions.
Error Code Description Recommended Action
E3
–
Scanner
failed / scanner
not found Unit is not recognized. Restart the QuickScan System
Scanning error
QuickScan did not read
the barcode properly.
Check that test strips have been
placed correctly in the tray, that the
barcode is in place, and that no debris
is on the barcode or the scanning
surface.
No cassettes
found
QuickScan cannot locate
the test strips in the
scanning area.
Check that the scanning surface is
clear of obstructions, and that the
strips have been placed in the tray
correctly. Press Read Test again.