07-02185A EB280
8
Legend Brands
NOTICE
:
The unit is fitted with
sensitive electronic sensors.
Protect the sensors from
impact and do not expose
them to water or cleaning
solution.
Vacuum or use compressed air
on both sides of the upright
(condenser) coil until it is clean.
Take care not to let the nozzle
touch the fins; as this may
damage the fins. A coil cleaner
product may be used on the
horizontal cold (evaporator) coil
only. Follow instructions on
product label. Take care not to
spray or wipe product on or near
any electrical components or
sensors. To clean the vertical
(condenser) coil, contact Service
for instructions.
To reassemble, follow the above
steps in reverse. Be sure to
reinstall heat exchange block in
the original orientation. When
installing the rear cover, carefully
thread the pump hose through
the hole in the back pocket
before putting the cover in place.
NOTICE
:
Rubber strips are
attached to the outside edges
of the evaporator and
condenser coils to provide an
airtight seal around the heat
exchange block. When
reinstalling the block, make
sure the seals are in place and
are not kinked or folded.
Rear cover
Side cover A
Side cover B
Filter
FIG. G: CLEANING
Pump hose – thread up through
hole in bottom of rear hose
pocket before reinstalling cover.
Condenser coil
Evaporator (cold) coil
Air-to-air heat
exchange block.
Arrows printed on
the block indicate
correct orientation
for installation.
