Maintenance And Service
R
outine
m
aintenance
:
At least once a year, run through the following procedures to ensure the system is clean and working
properly. Check the burner to see if all the ports are clear and clean. Check the pilot to make sure it is not
blocked by anything. The pilot flame should be blue with little or no yellow on the tips.
Warning:
Clearances must be sufficient to allow access for maintenance and service
Warning:
Failure to position the parts in accordance with this manual, or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
The venting system must be periodically examined; it is recommended the examination is done by a
qualified agency.
c
Leaning
t
he
g
Lass
:
When the fireplace has cooled
, remove the face of the fireplace along with the glass. See
M
aIntenance
a
nd
s
erVIce
- g
lass
d
oor
r
eMoVal
.
Check the gasket material on the back of the glass, making sure that
it is attached and intact.
During a cold start up, condensation will sometimes form on the glass. This is a normal condition with all
fireplaces. However, this condensation can allow dust and lint to cling to the glass surface. Initial paint
curing of the appliance can leave a slight film behind the glass, a temporary problem. The glass will need
cleaning about two weeks after installation.
Use a mild glass cleaner and a soft cloth
.
Abrasive
cleaners will damage the glass and painted surfaces.
Depending on the amount of use, the glass
should require cleaning no more than two or three times a season.
Do not clean the glass when it is
hot.
c
Leaning
t
he
f
iRebox
:
Remove all of the glass media from the tray, a vacuum cleaner with an empty canister or new bag works
best. At this time, inspect the burner tray for cracking or severe warping. If a problem is suspected,
contact the dealer. Check the glass media for large amounts of soot; a small amount on the bottom side
of the glass is normal. Re-install the glass as in the
s
econdary
I
nstallatIon
- g
lass
M
edIa
I
nstallatIon
section. If new or glass is required, contact your nearest ENVIRO dealer.
R
ePLacing
the
g
Lass
:
The door glass in the fireplace is a high temperature ceramic. If the glass is damaged in any way,
a factory replacement is required (see
P
arts
l
Ist
). Wear gloves when handling damaged glass door
assembly to prevent personal injury. Do not operate with the glass front removed, cracked or broken.
Removal and replacement of the glass from the door
must
be done by a licensed or qualified service
person.
The glass must be purchased from an ENVIRO dealer. No substitute materials are
allowed.
Remove the door (see page 11). The replacement glass will come with a new gasket installed.
Remove any silicone remnants from the door. Apply high temperature silicone to the two vertical faces
of the door and install the new piece of glass with gasket (be sure to maintain edge clearances). Apply
even pressure to the glass to allow the silicone to adhere to the gasket material.
10
