30
o
ptionaL
b
ase
s
heLf
& R
iseR
:
The E33 Base Shelf (1⅝” (41 mm) high) and Base Shelf Riser (2⅛” (54 mm) high) are components that
can be combined to create a riser with an overall height of 2
3
/
16
” (55 mm). This shelf can be installed
with or without the riser and can be used when the hearth in front of the unit is lower than the fireplace
opening. Additional Base Shelf Risers can be fastened together to increase the height in increments
of 2⅛” (54 mm). This Base Shelf may be used in conjunction with the any of the E33 surround panel
options, and it may also be used with the E33 Trimmable Surround. The Base Shelf and Riser are sold
separately.
Installation:
1. If unit is running, turn it off and
allow it to cool completely.
2. When using more than one riser
each level must be attached
using nine (9) #8 T-20 screws
provided (see Figure 42).
3. If installing with riser(s) the
Base Shelf is to be fastened
to the riser(s) with one T-20
screw at each end of the back
Figure 42: Combining 2 Base Shelf
Riser.
Figure 43: Installing Base Shelf
onto Riser.
(see Figure 43).
4. The leveling legs on the E33 may need to be adjusted to match
the height of the riser and shelf.
5. Center the Base Shelf assembly in front of the unit flush with the
bottom of the unit.
6. Install surround if required.
Secondary Installation
A
DETAIL A
SCALE 3 : 1
s
afety
s
cReen
i
nstaLLation
/ R
emoVaL
:
To install the safety screen hold it upright in front of the fireplace with four (4) hooks pointing towards
the fireplace. Slide the hooks into the corresponding brackets on each side of the cabinet (see figures 40
and 41). Ensure the hooks are secure to confirm correct installation. To remove the safety screen unhook
it from the brackets by liffting up and out.
Figure 40: Installing Safety Screen onto
Cabinet Bracket (Parts removed for clarity)
Figure 41: Installing Safety Screen onto
Cabinet Brackets
